Installation & setup
How to install and use Pupillo.
Use this page to train staff on mounting the device, preparing the patient and beginning the pre-operative session.
Installation. Once device is powered on do not press the on swtich again to power off. The device powers off on its own in 20 minutes.
Setup sequence
A simple pre-operative workflow
1
Inspect
Confirm that the device, spectacle mount and cable or charging system are undamaged and dry.
2
Mount
Secure Pupillo on the specified side of the spectacle frame according to the device guide.
3
Prepare
Instill dilating drops as prescribed, seat the patient comfortably and position the frame correctly.
4
Run
Start the prescribed Pupillo session and supervise the patient according to clinic protocol.
Important handling points
- Keep the device dry and away from liquids.
- Do not open, modify or attempt to repair the enclosure.
- Clean only as described in the approved instructions for use.
- Stop use if the enclosure, LEDs, mount or wiring appear damaged.
- Use only approved chargers, accessories and spectacle mounts.
